5 (734) In stock
Hi all, I am currently trying to inflate boundary layer of 1st layer < 1e-5. When I try to make the inflation layer smaller, the layer did not grow. I tried using both relative and absolute size and also played with the advance options. Can you give me some feedback on what I did wrong? From the mesh log, I can see that the inflation layer is as intended and after “Selecting externalDisplacementMeshMover displacementMedialAxis” there is some iteration that causes the layer not to grow. This
794 questions with answers in MESH
SimScale - Another Fine Mesh
Boundary Layer Does Not Form - Except When Default Settings Used - Project Support - SimScale CAE Forum
794 questions with answers in MESH
Welcome To Your Digital Edition of and Sensor Technology: Tech Briefs, COMSOL News, Motion Design, PDF, Optics
Mesh inflation layer not shown - Project Support - SimScale CAE Forum
Inflation does not follow edge of airfoil
Week 3 - External flow simulation over an Ahmed body.
upFront.eZine News Archives
Week 3 - External flow simulation over an Ahmed body.
Mesh inflation layer not shown - Project Support - SimScale CAE Forum
7 Questions to Ask CAE Vendors of Structural Analysis and Simulation Software